SEWERAGE AND DRAINAGE
The use of plastics pipes for both pressure and a gravity sewer is extensive. In addition, there is rapid growth in the use of plastics liners for repair of old and leaking sewer installations.
Availability of large diameter plastics pipes at competitive prices gives design engineers an opportunity to select products on cost and performance basis. Long life expectancy, low maintenance requirements are major advantages in the use of plastics pipes for sewage and drainage applications.
As in water main pipe, HDPE is a comparable alternative to PVC pipe in sewer systems. HDPE sewer pipes are also available in diameters ranging from 4 inches to 36 inches, although for storm sewer, much of the demand is for 10 to 15 inch, while for sanitary 8 to 12 inch are popular diameters. At larger diameters, the major market share is held by concrete, primarily due to cost.
Prior to the 1960s most sewer systems were combined sewers, that is, carried both sanitary and storm water. The system had to be designed to carry large volumes of water during rain events, but otherwise the capacity was little used. In addition, when it did rain the flood of relatively fresh water often negatively impacted water treatment. Design changed so that by the mid 1960s sanitary and storm systems were designed and constructed separately. Storm sewers collect water from roof drains, parking lots and streets. Unlike sanitary sewers, storm wastewater is not typically treated and the flow is directly discharged into a receiving body of water.
Similar to water distribution use, PVC is dominant in the smaller size sewer pipe market with HDPE just beginning to seriously compete. These smaller lines are commonly used in the collection network of subdivisions. In this segment, the competing concrete pipe is non-reinforced concrete pipe in 8" and 10" sections. The smallest diameter reinforced concrete pipe is usually 12" pipe.
The flow formula for smooth pipe should be used to compute the gas flow rate through Polyethylene. It has been found that the Mueller formula for smooth wall pipe describes the flow characteristics of Polyethylene
